How do you adjust the bobbin tension on a Elna sewing machine?
How do you adjust the bobbin tension on a Elna sewing machine?
Locate the upper tension control dial on either the faceplate, near the needle-bar housing or on the upper arm of the machine head, depending on the Elna sewing machine model. If the top stitches are loose, turn the upper tension dial 1/4 turn to the right to tighten the tension.
How do I fix the tension on my bobbin?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
Why is my bobbin thread looping underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
Why is my sewing machine making loops underneath?
Looped stitches are usually caused by improper tension. If the loop is on the upper side, it may be corrected by loosening the top tension or by tightening the lower tension. If the loop is on the under side, it is usually best corrected by adjusting the upper tension.
Why does my sewing machine keep bunching the thread?
Your Thread Tension Is Too Tight Sewing machine manufacturers suggest that you don’t mess with your bobbin thread tension too much, but you should adjust your upper thread tension if you keep getting bunched up thread underneath your fabric. If your tension is too tight, it can pull your thread and break it.
Why is my bobbin thread not catching?
– Your thread could be caught on something between the needle and your spool of thread if so, your thread will be too tight for the needle to pick up the bobbin thread. – Make sure that the upper thread is threaded properly. – Re-thread your machine, if necessary.
How do I stop my sewing machine from looping?
How do you know thread tension is correct?
To test if the tension is correct, insert a bobbin in the bobbin case. Then hold it up by just the thread, the bobbin case shouldn’t move. Give a little jerk on the thread and if the bobbin case slides down slightly, then the tension if perfect. If it drops freely, then it’s too loose.