How do I configure a master and slave hard drive?

Steps

1. Restart your computer.
2. If prompted for a password, enter it and press the “Enter” key.
3. Navigate to the “CMOS Setup” and press “Enter”.
4. In the CMOS menu, find “Hard Disk” and then the “Primary Master” selection.
5. Move the cursor to the “Primary Slave” selection and press “Enter” again.
6. Edit step.

How do I make my SATA hard drive master and IDE slave?

Plug one end of a SATA data cable into the smaller L-shaped connector on the hard drive, and plug the other end into one of the SATA controllers on your computer’s motherboard. The SATA controllers are usually labeled SATA1, SATA2 and so on.

How do I boot a hard drive from slave?

BIOS Setup

1. Turn on or restart the computer.
2. Select “Boot” or “Advanced BIOS Features” using the arrow keys.
3. Select “Hard Disk Boot Priority,” “Hard Drive Order,” “HDD Boot Priority” or similar option, if available.
4. Select the secondary hard drive and press “Enter,” or press “+” to move the device to the top of the list.

What are jumper settings on a hard drive?

The jumper pins are similar to the pins on the I/O plate on a motherboard. You enable particular settings by placing a jumper shunt onto specific pins—creating an electrical circuit between them. The settings these jumpers enable are hard-coded onto a drive’s programmed printed circuit board.

What are the jumper settings on a hard drive?

How would you prepare master slave drive using jumper and bus connection and connect all drives to the motherboard?

Answer: You simply set the jumper to Cable Select on both drives and depending on where you connected them to the cable the computer would know which is Master and which is Slave. If you are going to use Cable Select you need a special 40 conductor IDE cable that would determine master and slave connections.

What are CSEL jumper settings for WD Eide hard drives?

WD EIDE hard drives are factory set with Cable Select (CSEL) jumper settings. The CSEL jumper setting protocol requires the use of a special interface cable. All hard drives in a CSEL-compliant system have the jumpers set in the same position.

How do you set the jumpers on a hard drive?

Setting the jumpers correctly on a hard drive requires the proper placement of a plastic-encased, metal jumper shunt over two pins on the hard drive jumper block, as shown in Figure 1. Figure 1. Jumper Block Location SATA Hard Drive Jumper Settings WD SATA hard drives are factory set for workstation/desktop use.

What are WD SATA hard drive jumpers used for?

WD SATA hard drives are factory set for workstation/desktop use. For enterprise storage requirements, the jumpers can be set to enable spread spectrum clocking or power-up in standby modes.

How to jumpered a drive as slave?

When a drive is jumpered as Slave, there must be a Master present. Cable Select: 1 or 2 drives connected to IDE cable, using Cable Select (CS) jumper for all drives on the cable.