Where is the code reader on a Dodge Caravan?

Plug an OBD-II scanner into the Caravan’s diagnostic Data Link Connection. The DLC outlet will be located beneath the driver’s side dash and somewhere between the gas pedal and the left side kick panel.

How can I read my engine code without a reader?

A. Using The Ignition Key

1. Step 1: Turn The Ignition Key. Switch ON and OFF the ignition key without running the engine.
2. Step 2: Check Your Dashboard. Right after the dash lights come up, they’ll turn off, except one—usually the service engine light.
3. Step 3: Note And Interpret The Check Engine Codes.

What does the check engine light mean on a Dodge Caravan?

If the check engine light in your 2017 Dodge Grand Caravan starts flashing, that means that the problem needs immediate attention and your Dodge should be delivered in immediately. This flashing light usually suggests a relentless engine misfire allowing unburned fuel to be dumped into the exhaust system.

What code is $7 e8?

16 Answers. Your $7E8 and the $7E9 are fuel/ air intake codes, as for the P1326 Ok, this code is set when the knock sensor detects vibrations from engine rod knock, however, it may be set falsely due to incorrect knock sensor logic programming in the engine control module.

How do you reset the check engine light on a 2010 Dodge Caravan?

A vehicle’s engine light must be switched on and off when the ignition switch is off. As a result, the computer reboots to retrieve the saved data. Once you place your key in the ignition, pull it off for 1-2 seconds, and then turn it back on for 1-2 seconds. It should be repeated three or four times.

Does OBD1 store codes?

Registered. If the trouble clears itself, the code may go away after a time. Otherwise, it should be stored.

How do you read a two digit check engine light code?

The first set of check engine light flashes will be the first digit of the two digit code. After the check engine light pauses for a short time it will start to blink again starting the second digit identification and completing the code’s second number.

What are the OBDII Codes on a Dodge Charger?

OBDII Dodge Code Definitions. 1 Dodge Codes 2 Trouble Code 3 P0171 4 P0300 5 P0301 6 P0340 7 P0420 8 P1000 – P1099 (Fuel and air metering and auxiliary emission control) 9 P1200 – P1299 (Fuel and air metering – injector circuit) 10 P1300 – P1399 (Ignition system or misfire)

How do you gather trouble codes for a Chrysler?

This guide will show you how to gather trouble code for Chrysler, Dodge and Plymouth automobiles built before 1996. This computer system is call OBD1. 1. To start gathering trouble codes turn the ignition key on off in rapid succession five times ending the cycle with the key in the on position.

How do you gather trouble codes on a Honda Accord?

To start gathering trouble codes turn the ignition key on off in rapid succession five times ending the cycle with the key in the on position. 2. Once this activation has started the check engine light will start to flash. The first set of check engine light flashes will be the first digit of the two digit code.