What size are the washer valves?

Two standard hoses are connected from the back of the washing machine to the water supply valves. The hot and cold hoses are ¾ inches in diameter. The hoses typically are marked to distinguish them from each other.

What are the valves behind washing machine?

Behind most washing machines is a set of valves called the washing machine shutoff valves. This makes it easy to hook up a washing machine to the house water supply. There are two shut off valves, for the hot and cold water.

How much does it cost to replace a washing machine valve?

It typically costs between $375 and $600 to replace a water shut-off valve, but the cost can reach as high as $800 or more depending on where the valve is, what type you have, and whether you hire a professional to do it.

Which valve is hot and cold for washer?

White Inlets: Facing the back of the washer, connect the hot water hose to the right port on the washer. Above the inlet will be an “H” or the word Hot. Connect the cold water hose to the left port. Above the inlet will be a “C” or the word Cold.

How do I know if my water valve is open or closed?

When the handle is parallel to the valve, it is closed, and when it is perpendicular to the valve, it is open.

Why is shut off valve leaking?

Since cut-off (shut-off) valves are rarely used, the washer inside the valve can become hard or covered with mineral deposits over time. When you close the valve then open it again, the washer on the valve stem may not seat properly, causing it to leak around the valve stem nut.

How many years does a washing machine last?

10-13 years
A typical washer should last 10-13 years. Top-loading washers typically last a few years longer than their front-loading brethren. If you use a stacked washer/dryer combo, you may have to replace both if one starts acting up.

How to install an Oatey washing machine box?

Oatey® Reversible Drain Metal Washing Machine Outlet Boxes can be used in commercial or residential applications which require supply valves and waste drain recessed into the wall. Available water hammer arrestor option provides water pressure shock arrestors required on supply lines to quick closing valves. Oatey products have earned the trust of plumbing professionals for over 100 years.

Do washing machines have check valves?

There is no check valve! Re: Do washing machines have check valves? Even if there was a proper standpipe and trap, if there were a sewage back up and the WM happens to be the lowest fixture on the DWV system, the raw sewage would overflow from the open standpipe, (where the hose drops into the top of it). Click to see full answer.

How to replace water inlet valve on washing machine?

– Washing machine will not fill with water – Washing machine not filling – Washing machine will not take powder – Washing machine will not take fabric conditioner – Washing machine buzzes but doesn’t do anything else

How to properly drain and vent a washing machine?

– Using a garment or lint bag can prevent the excess buildup of lint inside the drainpipes. – Inspect and clean the washer’s lint trap or filter. – Keep at least 1/2 inch between the drainpipe and discharge hose to ensure proper drainage. – Use proper detergents so that soap residue does not build up. – Clean the hoses and drainpipe often.