How do you use a Lux DMH110 thermostat?

The operation of LUX DMH110 does not involve any complex procedures. Just get up to the thermostat and use the up/down button to set the desired temperature. The thermostat will use this input and maintain the room temperature at this set point. You can set the temperature anywhere in the range of 450F to 900F.

How do you fix luxpro?

Luxpro Thermostat Not Working: Try These Troubleshooting Tips

1. Restart Your Device. This is the first thing you want to do whenever you have any issue with your Luxpro Thermostat.
2. Reset the Thermostat (Software Reset)
3. Check and Replace the Batteries.
4. Check for Any Wiring Issue.
5. Clean the Thermostat.

What does Stage 2 mean on a Lux thermostat?

Display reads “STG. 2” or “AUX” “STG. 2” is displayed when the thermostat is turning on the first and second stages of a conventional heating system. “AUX” is displayed when the thermostat is turning on the first and auxiliary heating stages on a heat pump.

What does the save button do on thermostat?

The Save button allows you to save energy and money while you are not at home by allowing one button press to decrease the set point temperature in winter and increasing the set point temperature during summer. Whenever you leave the house, hit the Save button to put it in Save mode.

How do I set the temperature on my Lux thermostat?

Heat-Only Luxpro Thermostats On your thermostat’s digital display, select heat mode. Press either the up or down arrow button and the word “SET” should appear. Then you should see the set temperature value flashing, which you can adjust with the up and down arrows in 1-degree increments.

Why is my LuxPro thermostat not working?

If your Luxpro thermostat stops working, first replace the batteries. Also check the circuit breaker, reset the thermostat, and check if the wires are faulty.

How do you reset a LuxPro thermostat?

Take the front of the thermostat off the wall and look for a small white round reset button on the right side labeled “H.W. Reset”. Hold this button down for at least 5 seconds. The screen should fully populate temporarily.

What does Stage 1 and 2 mean on my thermostat?

The second stage is the full capacity of your system. 1/3 compressor capacity is the 1st stage. 1st stage is more efficient than 2nd stage, but systems are designed to use both stages, so no worries there.

What does wait mean on Lux Pro thermostat?

The “Wait” message on a Honeywell Thermostat means the thermostat is waiting to activate the HVAC system. This is done to prevent damaging the HVAC system compressor. If the system is working properly, then “Wait” should disappear after a few minutes.

How do I Save my dmh110 system?

by the on/off cycling of the heating and cooling systems. position). DMH110’s “G” terminal. There are three push buttons below the unit’s display screen. These are changeable options, and to select the “SAVE” feature.

Can alkaline batteries be used with the dmh110?

Alkaline Batteries Only. The DMH110 is protected against normal static electric discharges. causing damage to the unit. Millivolt heating systems. It cannot be used with 3 wire zone valves, 120 volt

Can the dmh110 be used with a millivolt heating system?

The DMH110 is protected against normal static electric discharges. causing damage to the unit. Millivolt heating systems. It cannot be used with 3 wire zone valves, 120 volt heating systems, or multi-stage heat pumps.

How do I set the G Terminal on a dmh110?

DMH110’s “G” terminal. There are three push buttons below the unit’s display screen. These are changeable options, and to select the “SAVE” feature. button causes the word “SET” to appear on the screen. Once “SET” is associated direction.