What type of nebulizer is aerogen?

Aerogen ® Continuous Nebulization Tube Set For precision control of inhalation medication delivery.

How do I change my aerogen to continuous?

3 Screw the nebuliser end of the tubing onto the top of the nebuliser. 4 Press and hold the on/off button for 3 seconds from the off position to select the continuous mode. Aerogen’s recommended input rate of medication into the Aerogen Solo during continuous nebulisation is up to a maximum of 12 mL per hour.

Are aerogen syringes sterile?

This is a single patient use device not to be used on more than one patient to prevent cross infection. The components and accessories of the Aerogen Solo System, as packaged, are not sterile.

Is aerogen a mesh nebulizer?

Consequently, the Aerogen Pro and Aerogen Solo mesh nebulizers have become the delivery systems of choice for use with both invasive and noninvasive ventilators.

Is the aerogen nebulizer ultrasonic?

In a paediatric model with bias flow, the Aerogen Solo performed better than an ultrasonic when placed on the humidifier, similar deposition was observed at the wye6. Both ultrasonic nebulisers and Aerogen have controllers that drive them – but the ultrasonic nebuliser’s controller is bigger, bulkier and heavier.

Can you put mucomyst in an aerogen?

It is important to note that Aerogen’s metallic aerosol generator is made from a highly corrosive resistant material and as such, is not directly affected by the use of Mucomyst®.

Why does the aerogen go on the dry side?

Rain-out in the circuit due to aerosol delivery via the Aerogen Solo should be minimal. Placement back on the dry (ventilator) side of the humidifier may reduce rain-out because the large aerosol particles could rain-out in the humidifier chamber versus in the circuit.

How do you clean aerogen nebulizer?

Rinse parts with sterile water. 5. Shake excess water from parts and allow parts to fully air dry. Warning: Do not use abrasive or sharp tools to clean the nebulizer.

Can mucomyst be used in the aerogen?

What is the meaning of aerogen?

A gas-producing microorganism
[ âr′ə-jən, -jĕn′ ] n. A gas-producing microorganism.

How is aerogen put on Bipap?

Place the Aerogen Solo firmly into the T-piece. Insert the Aerogen Solo and the T-piece into the inspiratory limb of the breathing circuit. Insert medication into the Aerogen Solo. Press the on/off button on either Aerogen Controller for 1 second to select 30-minute mode.

How much current does an Aerogen generator produce?

My Aerogen wind generators provided a second source of continuous low level current output, and the majority of the time the batteries could accept the full output of the wind generators. When I cruised in the trade winds, each Aerogen produced ten amps of current in twenty knots of wind.

Why choose Aerogen 6 wind generators?

Modern cruising boats are hungry for power, and for us, the easiest way to get that power was with the Aerogen 6 wind generators.

What is the power consumption of the Aerogen Pro-X controller?

Note:The Aerogen Pro-X Controller is approved for use with Aerogen AC/DC adapter AG-AP1040-US (Manufacturer Reference: FRIWO FW7660/09) Power Consumption < 8 Watts (charging), 2.0 Watts (nebulizing). Patient Isolation Controller circuitry provides 4 kilovolt (kV) patient isolation and complies with IEC/EN 60601-1.

Where can I find the Aerogen system instruction manual?

System Instruction Manual System Instruction Manual www.aerogen.com Aerogen®Solo System Instruction Manual1 Contents