Why is my radio not working in my Tahoe?

Why is my radio not working in my Tahoe?

The Chevy Tahoe Radio Has No Sound The culprit could be a wide variety of issues, such as: A bad connection in the radio wiring system. A short in the radio wiring system. Antenna failure.

How do I unmute my radio in my Tahoe?

As you can see, if you need to unmute your audio, then all you need to do is press the on/off button on the radio. Don’t worry; your settings won’t reset. Instead, the audio will pick up where it was the last set. This includes if you are playing music on your phone via Bluetooth.

Can I install an aftermarket stereo on 2015 Tahoe?

The Metra 99-3015G dash kit will allow your installer to integrate a double-DIN multimedia receiver into the dash of a 2015 or newer Suburban, Tahoe or Yukon. The RadioPRO 5 RP5-GM51 allows an aftermarket radio to be integrated into late-model GMC and Chevrolet trucks and SUVs.

What causes a car radio to stop working?

The most likely reason for your radio’s sudden death is a blown fuse. All car radios have at least one fuse that protects it from power surges coming from somewhere else in the vehicle. The first thing you should do when your radio stops working is check its fuses and replace any that have blown.

How do I unmute my radio?

Answer provided by

  1. Press and hold the source button until the stereo turns off.
  2. Press and hold the function button until the unit beeps.
  3. Continue to press the function button until the telephone appears.
  4. Use the left or right buttons to select ATT.
  5. Press and hold the source button until it shuts off again.

Why do AUX cables stop working?

Check to see if the AUX cord is firmly connected to both devices. If this does not work and are only two rings, your cord is not compatible. If there are three rings, replace the auxiliary cord. If this does not work, the problem may be with the auxiliary cord jack and you may need to replace it.

Why does my radio keep switching to AUX?

when you plug a cable into the port it will automatically switch to the aux setting. if you already have a cable plugged in and hanging there, it might be triggering the port when driving/ going over bumps.