How do you fix a broken washing machine dial?

Glue any broken pieces on the exterior of the dial back together using a two-part epoxy glue. Wait at least 24 hours for the epoxy to set and cure completely. Stuff a small amount of modeling clay into the cylinder on the back of the dial, loosely filling the cylinder with clay.

What is the dial on a washing machine?

The dial on your General Electric (GE) washing machine controls is used each time the washer is used, as it not only allows you to select the desired wash cycle but also rotates, advancing the wash cycle.

How do you reset a front load GE washing machine?

To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.

What would make a washing machine Start button not work?

If the main control board does not properly control the motor, the filling valve, the drain motor, or the door lock, the washer will not start. The only way to determine if the control board is at fault is to visually inspect it. Check for burned areas or any component on the board that may look burned or damaged.

Should I wash towels on heavy duty?

Heavy Duty: Select this cycle for sturdy fabrics like towels and jeans. It is also appropriate for heavily soiled items. The cycle offers a longer wash cycle with high-speed agitation and a high-speed spin to remove as much moisture as possible.

How long do washing machines last on average?

10-13 years
How long does a washing machine last? A typical washer should last 10-13 years. Top-loading washers typically last a few years longer than their front-loading brethren.

How much does it cost to replace a washing machine timer?

On average, a washer timer replacement job will be between $100 and $280. Timers control how long a washing machine cycle lasts. If the machine isn’t starting or the cycle ends early, that’s a sign of a faulty timer.

How do I know if my washing machine motor coupler is broken?

Follow these instructions to find out if you have a broken motor coupler in your Whirlpool or Kenmore washing machine. Set the timer dial in the regular wash cycle. If the washer fills to the selected level and starts agitating properly, then the problem is not a broken motor coupler.

What to do if your washing machine lid switch is broken?

If your lid switch is broken, the timer won’t operate either, and repair is in order. Start by finding the lid switch, which is normally located beneath the main top. A pin or lever attached to the lid will activate the switch when the lid is closed. Unplug the washer and see if the switch is tripped by a lever or actuator when the lid shuts.

How do you remove the timer on a whirlpool washing machine?

If your timer knob has a skirt or dial surrounding it, push the timer knob in and unthread the knob by turning it counterclockwise. On some washers, there’s a plastic cap in the middle of the knob. You’ll need to pop the cap off to get to the fastener that holds the knob on.

What should I do if my washing machine is not working?

Get an appliance repairman. It could be as cheap as your lid switch or it could be most of the way to a new washer if your motor, transmission or clutch are dying.