How do I enable spanning-tree on HP ProCurve?

The first thing to do is to select your root bridge (the central most switch in your network). Enter CLI and type “configure” to enter config mode. Then enter “spanning-tree” to enable it. That’s all you need to do on a switch to get STP up and running.

Does HP still make ProCurve switches?

HP ProCurve was the name of the networking division of Hewlett-Packard from 1998 to 2010 and associated with the products that it sold. The name of the division was changed to HP Networking in September 2010.

Should I enable 802.1 D spanning-tree?

Using legacy 802.1D It works well despite its age, and you’ll find this type of spanning tree on just about every switch. Any switch that doesn’t support 802.1D is only useful in small isolated environments, and should never be connected to any other switches.

How do you configure multiple spanning tree Mstp on HP Procurve switches?

How to configure MSTP in HP switches?

1. Define the revision number in the MST region.
2. Define VLAN-to-instance mapping.
3. Define the priority for each.
4. Define the cost of the path (path-cost)
5. Define point-to-point links.
6. Enable MSTP.

What does a ProCurve Switch do?

The HP ProCurve 1410-8G, 1410-16G, and 1410-24G Switches are multiport switches that can be used to build high-performance switched workgroup networks. These switches are store-and-forward devices that offer low latency for high-speed networking.

Do HP switches have a lifetime warranty?

The 2520 switch is backed by the ProCurve Lifetime Warranty (2), which enables customers to better manage their overall networking expenses by providing value and choice for their business applications.

Should I disable spanning tree?

STP should never be disbaled unless you have an extremely good reason to do so. If you’re wanting to reduce the amount of time it takes for an access port to come up, you should configure it as an edge port instead of disabling STP.

Is spanning tree necessary?

STP can help prevent bridge looping on LANs that include redundant links. Without STP, it would be difficult to implement that redundancy and still avoid network looping. STP monitors all network links, identifies redundant connections and disables the ports that can lead to looping.

How to combine Cisco and HP ProCurve spanning tree networks?

To combine Cisco and HP ProCurve spanning tree networks, MSTP can be run on the Cisco devices, or PVST Cisco networks can be combined with MSTP HP ProCurve networks. Software version To support the compliant IEEE 802.1s-2002 standard, ensure that the Cisco devices have the latest software installed. Check the latest Cisco documentation for details.

What is the difference between Cisco ProCurve and Per VLAN Spanning Tree?

By default, Cisco supports Per VLAN Spanning Tree (PVST), while ProCurve supports only standards- based protocols—in this case, IEEE 802.1s Multiple Spanning Tree Protocol (MSTP) or IEEE 802.1w Rapid Spanning Tree Protocol (RSTP).

What should I consider when migrating from Cisco to HP ProCurve networks?

Although there are several areas of concern when migrating from Cisco to HP ProCurve networks, the two most important considerations are virtual LAN (VLAN) setup and Spanning Tree Protocol (STP) interoperability. Because HP ProCurve works to provide standards-based solutions, the routing protocols should conform to those standards.

Is there a difference between HP Procurve and Cisco nomenclature?

Nomenclature is likely to be an issue, because commands on HP ProCurve and other standards- based devices sometimes use different terminology than Cisco uses. Furthermore, the choice of Spanning Tree Protocol will be important, with Multiple Spanning Tree Protocol (MSTP) providing the best results on the HP ProCurve platform.